This entry was posted on Saturday, February 27th, 2010 at 3:05 am and is filed under build boat. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.
Part 17 Build a Putt PuttPop Pop Steam Boat s14make angle tool
Part 17 is Step 14, making a cardboard angle tool to set the angle between the aluminum boiler and the straws. You saved the pattern that printed out with the boiler pattern way back in part 7, step 4, didn’t you?!
You can find more DIY science projects like this at http://www.sciencetoymaker.org/
Duration : 0:2:8
8 Responses to “Part 17 Build a Putt PuttPop Pop Steam Boat s14make angle tool”
Leave a Reply
February 27th, 2010 at 3:05 am
@Bram97310 Thanks. …
@Bram97310 Thanks. If you have more of a bend you’ll have trouble getting the candle under. I have seen video responses where people have less of a bend and it still works. However, the engine might intercept less heat, which would slow it down.
Slater
February 27th, 2010 at 3:05 am
is it important in …
is it important in what kind of angle the strws are? btw very nice vids!
February 27th, 2010 at 3:05 am
35 degrees, but why …
35 degrees, but why not just use the pattern?
Slater
February 27th, 2010 at 3:05 am
what angle is used …
what angle is used for the bendy straws?
February 27th, 2010 at 3:05 am
It’s a PDF (Print …
It’s a PDF (Print Document Format) file which is widely used. I use this format because it holds the pattern to the right scale. PDF readers are free downloads, or maybe you can find someone who already has a PDF reader.
Slater
February 27th, 2010 at 3:05 am
hey cant get the …
hey cant get the prints i says it doest recognize the file
February 27th, 2010 at 3:05 am
thx it really works …
thx it really works try it people
February 27th, 2010 at 3:05 am
thx
thx